Honey Loucus
4 posters
Page 1 of 1
Honey Loucus
I,ve just got a fall bargin on a honey locus tree tthat I want to bonsai. It's proably a four yesr old tree in a five gallon pot. The trunk is about 2" in diameter. I'm going to cut it way back but i'm not sure what lenght to cut to. Should I cut on an angle or straight across ? It's close to being dorment now, no leaves. Can I cut it now or wait till spring. How much root should I cut back ? Is fifty per cent too much to start.
Thanks
Jerry Fikar
Thanks
Jerry Fikar
Jerry Fikar- Member
Re: Honey Loucus
It's "honey locust" (Gleditsia triacanthos). They make adequate, but not great bonsai (at least not that I have seen).
You need to slow down. I don't think you want to cut the roots and the top at the same time -- especially if you cut the top to the point where there's no foliage or branches. I'd recommend you wait until spring, then cut the top wherever you want. Cutting it square across always works, since you don't know where new branches will sprout. You can always trim off the stump later on.
Work on the roots after you have a mass of foliage up top -- later in the summer, or next spring.
You need to slow down. I don't think you want to cut the roots and the top at the same time -- especially if you cut the top to the point where there's no foliage or branches. I'd recommend you wait until spring, then cut the top wherever you want. Cutting it square across always works, since you don't know where new branches will sprout. You can always trim off the stump later on.
Work on the roots after you have a mass of foliage up top -- later in the summer, or next spring.
JimLewis- Member
Re: Honey Loucus
I've been working on one for a few years, and so far am finding it hard to get leaf reduction. I expect it will take many years.
bisjoe- Member
Re: Honey Loucus
I have always loved this tree in a landscape, and am also growing a few into hopefully being bonsai material, unfortunately as Jim said I have not seem many (only one in three years of looking)examples of them turning out to be an impressive specimen. Of course between my love for the tree itself, the fast growth rate (which could also be an issue later) and the challenge I figured I would give it a shot. I think however with the type of foliage that they produce, to create a more believable image one would have to train them to be a larger bonsai, unless substantial leaf reduction was possible. If anyone has any works in progress I would love to see some pictures.
Steven- Member
Similar topics
» any one else doing any Mesquite Bonsai out there?
» Cannabis bonsai nursery
» Mushrooms of the SF Bay Area Article link
» Cannabis bonsai nursery
» Mushrooms of the SF Bay Area Article link
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|