Internet Bonsai Club
Would you like to react to this message? Create an account in a few clicks or log in to continue.

First ever cuts and wire (juniper)

3 posters

Go down

First ever cuts and wire (juniper) Empty First ever cuts and wire (juniper)

Post  snidecal000 Sun May 13, 2012 5:47 pm

Hello all, and happy mothers day. I did my first cuts and wiring yesterday and I am wondering if I have got the right start. Im looking to make sure i didnt botch this too bad. Please feel free to tell me if you see changes that should be made. Thank you!

Cale Snider
First ever cuts and wire (juniper) P1000612
First ever cuts and wire (juniper) P1000613
snidecal000
snidecal000
Member


Back to top Go down

First ever cuts and wire (juniper) Empty Re: First ever cuts and wire (juniper)

Post  Billy M. Rhodes Sun May 13, 2012 6:27 pm

Too many directions to look. One of the "rules" is to have a "line" that the eye can follow. You have three, right, left and down. Makes looking at the tree conflicted.
Billy M. Rhodes
Billy M. Rhodes
Member


Back to top Go down

First ever cuts and wire (juniper) Empty Re: First ever cuts and wire (juniper)

Post  snidecal000 Sun May 13, 2012 6:36 pm

should i cut the right side? i was told by a woman in my grandmothers club that i should leave them and they would help the other side grow.
snidecal000
snidecal000
Member


Back to top Go down

First ever cuts and wire (juniper) Empty Re: First ever cuts and wire (juniper)

Post  Billy M. Rhodes Sun May 13, 2012 7:03 pm

The amount of foliage above a given point will draw energy and the area below will get thicker to bring up the additional nutrients. So, yes, leaving the right side as a "sacrificial" branch will cause the trunk to thicken. Leaving all the branches on the left side will cause the branches to grow also. But, we usually do all of this work before we put it in a bonsai pot and wire the tree.
Billy M. Rhodes
Billy M. Rhodes
Member


Back to top Go down

First ever cuts and wire (juniper) Empty Re: First ever cuts and wire (juniper)

Post  DreadyKGB Thu May 17, 2012 1:11 am

To be blunt the wiring on the thicker trunk seems pointless, the wire should be done at a 45 degree angle to provide the best support for the intended movement. With thicker wire and better angle the larger trunk could be brought over the smaller trunk to create a better image. Also some movement could be added to the smaller trunk and a nicer overall image could be created. Maybe something like this:

First ever cuts and wire (juniper) Junipe10

todd
DreadyKGB
DreadyKGB
Member


Back to top Go down

First ever cuts and wire (juniper) Empty Re: First ever cuts and wire (juniper)

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum